Manuals

English

INTAR Screwdriver
Holder Installation
Guide

Basic installation guide for V2 holder (please read before installing

Tools required:

  • Tape Measure
  • Power Drill
  • #2 Phillips Screwdriver
  • Drill Bit

Box contents:

  • CAUTION:
Risk of falling objects. Securely install the Intar Drill Holder to the wall per the mounting instructions. Failure to do so could result in minor or moderate injury.

Holder Installation

1

Check that there is enough space for installation of the holder

2

Use the tape measure to measure hole positions and mark them. Use the power drill to make holes for the anchors in the marked position.

3

Insert the anchors into the drilled holes.

4

Place the included screws into anchors and fasten them so the screw head will stick out.

5

Place the Holder on the wall over the screws and tighten the screws through holder’s square holes .

6

Place your tools in the holder.
Back